Gianni

Is quite simple make a simple stand for your MuIN LCD! All you need is:

• A sheet of PVC, at least 110x110 millimeters
• Ruler
• Cutter
• A pencil
• A drill
• 4 F/F hex spacers, 12mm height with screws
• A Caliper (optional)

Using Caliper or Ruler, measure your display's dimensions and paint the shapes on PVC using the pencil. The external dimensions I've used for the stand are 110 x 100mm:

Cut the display window using the cutter and drill the 4 holes used to anchor display on the stand

Screw-in the hex spacers on the back side of LCD.

In the following pic you can see I've used 2 F/F 1.2mm Hex spacers on the upper side of LCD and 2 F/M 1.2mm Hex spacers on the back side. On the male side of 2 lower hex spacers I've screwed in 2 F/F 2.5mm hex spacers and then I've attached here a small piece of a protoboard:

The protoboard is then connected on 8 pin male header of muin LCD using a female header soldered on the back side:

Here you can see some other pics:

Finally you can attach LCD on the stand using 4 screws:

On the back side, in order to mantain the assembly in upper position, I've used two common "L" washers mounted on lower hex spacers:

Your simple MuIN LCD stand is ready to display all that you want, just in front of you !!